Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 863

Dell Force10 provides additional MIB Objects to view copy statistics. These are provided in Table 42-5. Table 42-5. MIB Objects for Copying Configuration Files via SNMP MIB Object copyState OID .1.3.6.1.4.1.6027.3.5.1.1.1.11 copyTimeStarted .1.3.6.1.4.1.6027.3.5.1.1.1.12 copyTimeCompleted .1.3.6.1.4.1.6027.3.5.1.1.1.13 copyFailCause .1.3.6.1.4.1.6027.3.5.1.1.1.14 copyEntryRowStatus .1.3.6.1.4.1.6027.3.5.1.1.1.15 Values Description 1= running 2 = successful 3 = failed Specifies the state of the copy operation. Time value Specifies the point in the up-time clock that the copy operation started. Time value Specifies the point in the up-time clock that the copy operation completed. 1 = bad file name Specifies the reason the copy request 2 = copy in progress failed. 3 = disk full 4 = file exists 5 = file not found 6 = timeout 7 = unknown Row status Specifies the state of the copy operation. Uses CreateAndGo when you are performing the copy. The state is set to active when the copy is completed. To obtain a value for any of the MIB Objects in Table 42-5: Step 1 Task Get a copy-config MIB object value. snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address [OID.index | mib-object.index • index is the index value used in the snmpset command used to complete the copy operation. Note: You can use the entire OID rather than the object name. Use the form: OID.index, as shown in Figure 42-13. Figure 42-13 and Figure 42-14 are examples of using the command snmpget to obtain a MIB object value. These examples assume that: • the server OS is Unix • you are using SNMP version 2c • the community name is public, and • the file f10-copy-config.mib is in the current directory. Note: In Unix, enter the command snmpset for help using this command. Simple Network Management Protocol (SNMP) | 863