Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 415

Figure 19-34. Setting Auto-Negotiation Options FTOS(conf)# int gi 0/0 FTOS(conf-if)#neg auto FTOS(conf-if-autoneg)# ? end Exit from configuration mode exit Exit from autoneg configuration mode mode Specify autoneg mode no Negate a command or set its defaults show Show autoneg configuration information FTOS(conf-if-autoneg)#mode ? forced-master Force port to master mode forced-slave Force port to slave mode FTOS(conf-if-autoneg)# For details on the speed, duplex, and negotiation auto commands, see the Interfaces chapter of the FTOS Command Reference Guide. Adjust the keepalive timer Use the keepalive command to change the time interval between keepalive messages on the interfaces. The interface sends keepalive messages to itself to test network connectivity on the interface. To change the default time interval between keepalive messages, use the following command: Command Syntax keepalive [seconds] Command Mode Purpose INTERFACE Change the default interval between keepalive messages. To view the new setting, use the show config command in the INTERFACE mode. View Advanced Interface Information Display Only Configured Interfaces The following options have been implemented for show [ip | running-config] interfaces commands for (only) linecard interfaces. When the configured keyword is used, only interfaces that have non-default configurations are displayed. Dummy linecard interfaces (created with the linecard command) are treated like any other physical interface. Figure 19-35 lists the possible show commands that have the configured keyword available: Interfaces | 415