Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 184

www.dell.com | support.dell.com Step 3 Command Syntax Command Mode Purpose You must Configure Peer Groups before assigning it a remote AS. neighbor {ip-address | CONFIG-ROUTER-BGP Enable the BGP neighbor. peer-group-name} no shutdown Note: When you change the configuration of a BGP neighbor, always reset it by entering the clear ip bgp command in EXEC Privilege mode. Enter show config in CONFIGURATION ROUTER BGP mode to view the BGP configuration. Use the show ip bgp summary command in EXEC Privilege mode to view the BGP status. Figure 8-12 shows the summary with a 2-Byte AS Number displayed; Figure 8-13 shows the summary with a 4-Byte AS Number displayed. Figure 8-12. Command example: show ip bgp summary (2-Byte AS Number displayed) R2#show ip bgp summary BGP router identifier 192.168.10.2, local AS number 65123 BGP table version is 1, main routing table version 1 1 network entrie(s) using 132 bytes of memory 1 paths using 72 bytes of memory BGP-RIB over all using 73 bytes of memory 1 BGP path attribute entrie(s) using 72 bytes of memory 1 BGP AS-PATH entrie(s) using 47 bytes of memory 5 neighbor(s) using 23520 bytes of memory 2-Byte AS Number Neighbor AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/Pfx 10.10.21.1 10.10.32.3 100.10.92.9 192.168.10.1 192.168.12.2 R2# 65123 65123 65192 65123 65123 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 never 0 never 0 never 0 never 0 never Active Active Active Active Active 184 | Border Gateway Protocol