Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 961

Figure 49-15. Command Example: track FTOS(conf-if-gi-1/1)#vrrp-group 111 FTOS(conf-if-gi-1/1-vrid-111)#track gigabitethernet 1/2 FTOS(conf-if-gi-1/1-vrid-111)# Figure 49-16. Command Example Display: track in VRID mode FTOS(conf-if-gi-1/1-vrid-111)#show conf ! vrrp-group 111 advertise-interval 10 authentication-type simple 7 387a7f2df5969da4 no preempt priority 255 track GigabitEthernet 1/2 virtual-address 10.10.10.1 virtual-address 10.10.10.2 virtual-address 10.10.10.3 virtual-address 10.10.10.10 FTOS(conf-if-gi-1/1-vrid-111)# VRRP initialization delay VRRP initialization delay is supported on the z and platforms. When configured, VRRP is enabled immediately upon system reload or boot. VRRP initialization can be delayed to allow IGP and EGP protocols to be enabled prior to selecting the VRRP Master. This delay ensures that VRRP initializes with no errors or conflicts. The delay can be configured for up to 15 minutes, after which VRRP enables normally. The delay timer is set on individual interfaces and is supported on all physical interfaces, VLANS and LAGs. When both CLIs are configured, the later timer rules the VRRP enabling. For example, if vrrp delay reload 600 and vrrp delay minimum 300, the following behavior occurs: • When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and configured for vrrp. • When an interface comes up and becomes operational, the system waits 300 seconds (5 minutes) to bring up VRRP on that interface. Task Command Syntax Set the delay time for VRRP initialization on an individual interface. This is the gap between an interface coming up and being operational, and VRRP enabling. vrrp delay minimum seconds Seconds range: 0-900 Default: 0 Command Mode INTERFACE Virtual Router Redundancy Protocol (VRRP) | 961