Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 61

Synchronize log messages You can configure FTOS to filter and consolidate the system messages for a specific line by synchronizing the message output. Only the messages with a severity at or below the set level appear. This feature works on the terminal and console connections available on the system. To synchronize log messages, use these commands in the following sequence starting in the CONFIGURATION mode: Step Command Syntax Command Mode Purpose 1 line {console 0 | vty number [end-number] | aux 0} CONFIGURATION Enter the LINE mode. Configure the following parameters for the virtual terminal lines: • number range: zero (0) to 8. • end-number range: 1 to 8. You can configure multiple virtual terminals at one time by entering a number and an end-number. 2 logging synchronous [level severity-level LINE | all] [limit] Configure a level and set the maximum number of messages to be printed. Configure the following optional parameters: • level severity-level range: 0 to 7. Default is 2. Use the all keyword to include all messages. • limit range: 20 to 300. Default is 20. To view the logging synchronous configuration, use the show config command in the LINE mode. Enable timestamp on syslog messages syslog messages, by default, do not include a time/date stamp stating when the error or message was created. Management | 61