Dell Force10 Z9000 FTOS Configuration Guide for Z9000 System - Page 243

option configfile "ftp://admin:[email protected]/pt-s4810-12"; FTP URL with IP address option configfile "http://Guest-1/pt-s4810-12"; HTTP URL with DNS option configfile "pt-s4810-12"; TFTP ##### bootfile-name could be given in the following way option bootfile-name "ftp://admin:admin@Guest-1/ FTOS-SE-8.3.10.1.bin"; FTP URL with DNS option bootfile-name "http://30.0.0.1/FTOS-SE-8.3.10.1.bin"; HTTP URL with IP address option bootfile-name "tftp://30.0.0.1/FTOS-SE-8.3.10.1.bin"; TFTP URL with IP address ) File Server Set up a file server and ensure connectivity. The file server that holds the boot and configuration files must be configured to allow file transfers to the switch. The system recognizes FTP, SFTP, TFTP, HTTP, HTTPS, SCP, USB, and Flash URLs. For example: • tftp://server ip or name/filename • ftp://user:passwd@serverip or name//mypath/FTOS-A.B.C.D.bin • flash://filename • http://server ip • name/filename When loading the FTOS image, if the FTOS image on the server is different from the image on the local Flash, the system downloads the image from the server onto the local Flash and reloads using that image. If it is the same image, the system loads the configuration file, if present, or the startup-config without downloading a new image. Domain Name Server Set up a Domain Name Server (DNS) to determine the host name applied in the switch startup configuration when no configuration file is retrieved from the DHCP server. The DNS server is contacted only when no configuration file is contained in a DHCP server response and the host name is not resolved from the network-config file on the switch. Refer to the FTOS Configuration Guide, IPv4 Addressing chapter, Resolution of Host Names for information. Reload Modes Bare Metal Provisioning supports two types of reload modes: BMP mode and Normal mode. Bare Metal Provisioning 3.0 (BMP 3.0) | 243