Dell Inspiron m301z AMD Service Manual - Page 47

Replacing the Speaker

Get Dell Inspiron m301z PDF manuals and user guides View all Dell Inspiron m301z manuals
Add to My Manuals
Save this manual to your list of manuals

Page 47 highlights

1 speaker cable connector 2 screws (2) 10. Note the routing of the speaker cable and remove the speaker from the computer base. Replacing the Speaker 1. Follow the instructions in Before You Begin. 2. Place the speaker in the computer base. 3. Replace the two screws that secure the speaker to the computer base. 4. Connect the speaker cable to the connector on the system board. 5. Slide the hard-drive cable and the status light board cable into their connectors on the system board. Press down on the connector latches to secure the cables. 6. Press the adhesive side of the status light board cable over the speaker. 7. Replace the palm rest (see Replacing the Palm Rest). 8. Replace the keyboard (see Replacing the Keyboard). 9. Replace the module cover (see Replacing the Module Cover). 10. Replace the battery (see Replacing the Battery). CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in damage to the computer. Back to Contents Page

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
10.
Note the routing of the speaker cable and remove the speaker from the computer base.
Replacing the Speaker
1.
Follow the instructions in
Before You Begin
.
2.
Place the speaker in the computer base.
3.
Replace the two screws that secure the speaker to the computer base.
4.
Connect the speaker cable to the connector on the system board.
5.
Slide the hard-drive cable and the status light board cable into their connectors on the system board. Press down on the connector latches to secure
the cables.
6.
Press the adhesive side of the status light board cable over the speaker.
7.
Replace the palm rest (see
Replacing the Palm Rest
).
8.
Replace the keyboard (see
Replacing the Keyboard
).
9.
Replace the module cover (see
Replacing the Module Cover
).
10.
Replace the battery (see
Replacing the Battery
).
Back to Contents Page
1
speaker cable connector
2
screws (2)
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.