Dell Latitude CPi A User Manual - Page 7

Service Manual, When the display assembly is open nearly 180 degrees, use a book or something - latitude cpi a manual

Get Dell Latitude CPi A PDF manuals and user guides View all Dell Latitude CPi A manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

This manual provides instructions for removing and replacing field-replaceable components, assemblies, and subassemblies in your Dell Latitude portable computer. Unless otherwise noted, each procedure in this chapter assumes the following: The computer and any attached peripherals are turned off, and the peripherals are disconnected from the input/output (I/O) panel on the back of the computer. A part can be replaced by performing the removal procedure in reverse order. When the display assembly is open nearly 180 degrees, use a book or something similar to support it. The angle of the display assembly with respect to the bottom case should never be allowed to exceed 180 degrees. Also, when performing the procedures in this manual, the locations or directions relative to the computer are as shown in Figure 1 unless otherwise specified. back of computer left side right side front of computer Dell Latitude CPi A Service Manual 1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
Dell Latitude CPi A Service Manual
1
·µ¸¸¹º»¼´½´¾¿µ¹º±À½ºÁ
µÃĽŵºÆ¼³¾¼¸
This manual provides instructions for removing and replacing field-replaceable
components, assemblies, and subassemblies in your Dell Latitude portable
computer. Unless otherwise noted, each procedure in this chapter assumes
the following:
±
The computer and any attached peripherals are turned off, and the peripherals
are disconnected from the input/output (I/O) panel on the back of the
computer.
±
A part can be replaced by performing the removal procedure in reverse order.
When the display assembly is open nearly 180 degrees, use a book or something
similar to support it. The angle of the display assembly with
respect to the
bottom case should never be allowed to exceed 180 degrees. Also, when
performing the procedures in this manual, the locations or directions relative
to the computer are as shown in Figure 1 unless otherwise specified.
±²³´µ¶·¸¹··º»¼½´¾¶µ·¿µ²¶À¾Á¾²»À
right side
left side
back of computer
front of computer