Dell OptiPlex 5090 Tower Service Manual - Page 10
Removing and installing components, Recommended tools, Screw List
![]() |
View all Dell OptiPlex 5090 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
2 Removing and installing components NOTE: The images in this document may differ from your computer depending on the configuration you ordered. Recommended tools The procedures in this document require the following tools: ● Phillips #0 screwdriver ● Phillips #1 screwdriver ● Flat headed screwdriver ● Plastic scribe Screw List The following table shows the screw list and the images for different components. NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is restored when the component is replaced. NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surface when replacing a component. NOTE: Screw color may vary with the configuration ordered. Table 1. Screw list Component Side cover Screw type #6-32 Quantity 2 Image M.2 2230/2280 Solid-state drive WLAN card Power supply unit Processor fan and heat-sink assembly System board M2x3.5 1 M2x3.5 1 #6-32 3 #6-32 (Captive) 4 #6-32 11 10 Removing and installing components
![](/manual_guide/products/dell-optiplex-5090-tower-service-manual-38cd161/10.png)