Dell OptiPlex 5090 Tower Service Manual - Page 20
Installing the 2.5-inch hard-disk drive bracket
View all Dell OptiPlex 5090 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Steps 1. Pull one side of the hard-disk drive bracket to disengage the pins on the bracket from the slots on the drive. 2. Lift the hard-disk drive out of the bracket. NOTE: The orientation or the SATA connector marking on the hard-disk drive so that you can replace it correctly. Installing the 2.5-inch hard-disk drive bracket Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following image indicates the location of the 2.5-inch hard-disk drive bracket and provides a visual representation of the installation procedure. 20 Removing and installing components
Steps
1.
Pull one side of the hard-disk drive bracket to disengage the pins on the bracket from the slots on the drive.
2.
Lift the hard-disk drive out of the bracket.
NOTE:
The orientation or the SATA connector marking on the hard-disk drive so that you can replace it correctly.
Installing the 2.5-inch hard-disk drive bracket
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the 2.5-inch hard-disk drive bracket and provides a visual representation of the
installation procedure.
20
Removing and installing components