Dell OptiPlex 5090 Tower Service Manual - Page 54
Intrusion switch, Removing the intrusion switch
View all Dell OptiPlex 5090 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Steps 1. Slide the power-supply unit into the chassis until the securing tab snaps into position. 2. Replace the three (#6-32) screws to secure the power-supply unit to the chassis. 3. Route the power cable through the routing guides on the chassis and connect the power cables to their respective connectors on the system board. Next steps 1. Install the 3.5-inch hard-disk drive assembly. 2. Install the fan duct. 3. Install the side cover. 4. Follow the procedure in after working inside your computer. Intrusion switch Removing the intrusion switch Prerequisites 1. Follow the procedure in before working inside your computer. 2. Remove the side cover. 3. Remove the fan duct. About this task The following image indicates the location of the intrusion switch and provides a visual representation of the removal procedure. 54 Removing and installing components