Dell OptiPlex 5090 Tower Service Manual - Page 49
Installing the power button
View all Dell OptiPlex 5090 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Steps 1. Remove the two (#6x32) screws that secures the front I/O bracket to the system chassis. 2. Disconnect the power-button cable from the connector on the system board. 3. Press the release tabs on the power-button head and slide the power-button cable out from the front-side chassis of the computer. 4. Pull the power-button cable out from the computer. Installing the power button Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the power button and provide a visual representation of the installation procedure. Removing and installing components 49
Steps
1.
Remove the two (#6x32) screws that secures the front I/O bracket to the system chassis.
2.
Disconnect the power-button cable from the connector on the system board.
3.
Press the release tabs on the power-button head and slide the power-button cable out from the front-side chassis of the
computer.
4.
Pull the power-button cable out from the computer.
Installing the power button
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power button and provide a visual representation of the installation procedure.
Removing and installing components
49