Dell OptiPlex 7010 Owner's Manual (Desktop) - Page 37
Installing The System Board - usb ports not working
View all Dell OptiPlex 7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
19. Internal USB Connector (INT_USB) 20. Password Jumper (PSWD) 21. RTC reset jumper (RTCRST) Installing The System Board 1. Align the system board to the port connectors and place the system board in the chassis. 2. Tighten the screws securing the system board to the chassis. 3. Connect all the cables to the system board. 4. Install the processor. 5. Install the heat sink. 6. Install the memory. 7. Install the expansion card. 8. Install the front bezel. 9. Install the cover. 10. Follow the procedures in After Working Inside Your Computer. 37
19.
Internal USB Connector (INT_USB)
20.
Password Jumper (PSWD)
21.
RTC reset jumper (RTCRST)
Installing The System Board
1.
Align the system board to the port connectors and place the system board in the chassis.
2.
Tighten the screws securing the system board to the chassis.
3.
Connect all the cables to the system board.
4.
Install the processor.
5.
Install the heat sink.
6.
Install the memory.
7.
Install the expansion card.
8.
Install the front bezel.
9.
Install the cover.
10.
Follow the procedures in
After Working Inside Your Computer
.
37