Dell OptiPlex Micro Plus 7010 Owners Manual - Page 35
Solid-state drive, Removing the M.2 2230 solid-state drive from slot 0
View all Dell OptiPlex Micro Plus 7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Steps 1. Insert the right-side front-bezel tabs into the corresponding slots on the side cover. 2. Push the left-side of the front bezel towards the side cover, snapping the tabs into position. Next steps 1. Install the side cover. 2. Follow the procedure in After working inside your computer. Solid-state drive Removing the M.2 2230 solid-state drive from slot 0 Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the side cover. About this task NOTE: Depending on the configuration ordered, your computer may have an M.2 2230 or an M.2 2280 solid-state drive installed in solid-state drive slot 0 (M.2 PCIe SSD 0) on the system board. NOTE: This procedure is applicable for computers where an M.2 2230 solid-state drive is installed in solid-state drive slot 0 (M.2 PCIe SSD 0) on the system board. Removing and installing Customer Replaceable Units (CRUs) 35