Dell OptiPlex Micro Plus 7010 Owners Manual - Page 62
Installing the optional Type-C module, Processor, Removing the processor
View all Dell OptiPlex Micro Plus 7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Installing the optional Type-C module Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The following images indicate the location of the optional Type-C module and provide a visual representation of the installation procedure. Steps 1. To remove the dummy metal bracket, insert a flat-head screwdriver in the hole of the bracket. Push the bracket to release the bracket, and then lift the bracket out from the system. NOTE: This step applies if you are upgrading the system with no existing I/O module. 2. Connect the Type-C DisplayPort cable to the system board. 3. Connect the Type-C USB cable to the system board. 4. Insert the optional Type-C module into its slot from the inside of your computer. 5. Replace the two (M3x3) screws that secure the optional Type-C module. Next steps 1. Install the side cover. 2. Follow the procedure in After working inside your computer. Processor Removing the processor Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the side cover. 3. Remove the speaker. 4. Remove the fan. 5. Remove the heat sink. 62 Removing and installing Field Replaceable Units (FRUs)