Dell PowerConnect B-RX BigIron RX Series Configuration Guide v02.8.00 - Page 578

18 Configuring multicast traffic engineering Table 99 identifies the profile used for network control traffic which is identified using an independent flag. TABLE 99 Qos profile QOS profile index QOS profile index (depending on network port) Comments Low priority DP1 Low priority DP1 Low priority DP1 Low priority DP0 Low priority DP0 High priority DP1 High priority DP1 High priority DP1 High priority DP0 0,1,2,3 0,1,2,3 0,1,2,3 4,5,6,7 4,5,6,7 8,9,10,11 8,9,10,11 8,9,10,11 12,13,14,15 Only used for control traffic Mirroring ports The 16x 10GE module supports mirroring, but with the following limitations: • A 16X10GE port cannot be configured as mirror port. • Only one port can be monitored at any time from ports 1 - 8, and one port can also be monitored at any time from ports 9 - 16. • The mirror port for ingress or egress should be the same port, they cannot be monitored on multiple separate mirror ports. • Mirror(analyzer) ports cannot be assigned to the 16x10GE module. You can monitor traffic on 16x10 ports. Supported ACLs The 16x10GE module supports standard, extended, named and numbered egress ACLs. Refer to Chapter 21, "Access Control List" for additional information. Configuring QoS for the 16 x 10G module New CLI commands have been added to allow alternating between server and storage modes on the 10 x 16GE module. The new commands are part of the qos group, and configured at the interface level. Configuration steps 1. To set the group port 1 weight, low prioriy traffic, BigIron RX(config-if-e10000-4/1)#qos rcv-scheduler wfq 1 2. To set the group port 1 weight, high prioriy traffic, BigIron RX(config-if-e10000-4/1)#qos rcv-scheduler wfq 1 2 502 BigIron RX Series Configuration Guide 53-1002253-01