Dell PowerConnect B-RX BigIron RX Series Configuration Guide v02.8.00 - Page 923

Displaying BGP4 information 26 TABLE 130 BGP4 route information (Continued) This field... Displays... Origin Weight Atomic Aggregation ID Aggregation AS Originator Cluster List Learned From Admin Distance Adj_RIB_out Communities The source of the route information. The origin can be one of the following: • EGP - The routes with this set of attributes came to BGP through EGP. • IGP - The routes with this set of attributes came to BGP through IGP. • INCOMPLETE - The routes came from an origin other than one of the above. For example, they may have been redistributed from OSPF or RIP. When BGP4 compares multiple routes to a destination to select the best route, IGP is preferred over EGP and both are preferred over INCOMPLETE. The value that this router associates with routes from a specific neighbor. For example, if the router receives routes to the same destination from two BGP4 neighbors, the router prefers the route from the neighbor with the larger weight. Whether network information in this route has been aggregated and this aggregation has resulted in information loss. NOTE: Information loss under these circumstances is a normal part of BGP4 and does not indicate an error. The router that originated this aggregator. The AS in which the network information was aggregated. This value applies only to aggregated routes and is otherwise 0. The originator of the route in a route reflector environment. The route-reflector clusters through which this route has passed. The IP address of the neighbor from which the device learned the route. The administrative distance of the route. The number of neighbors to which the route has been or will be advertised. This is the number of times the route has been selected as the best route and placed in the Adj-RIB-Out (outbound queue) for a BGP4 neighbor. The communities the route is in. Displaying BGP4 route-attribute entries The route-attribute entries table lists the sets of BGP4 attributes stored in the router's memory. Each set of attributes is unique and can be associated with one or more routes. In fact, the router typically has fewer route attribute entries than routes. To display the IP route table, enter the following command. BigIron RX# show ip bgp attribute-entries Syntax: show ip bgp attribute-entries Here is an example of the information displayed by this command. A zero value indicates that the attribute is not set. BigIron RX Series Configuration Guide 847 53-1002253-01