Dell PowerConnect B-RX BigIron RX Series Configuration Guide v02.8.00 - Page 768

25 Configuring OSPF • ip ospf hello-interval • ip ospf md5-authentication key-activation-wait-time | key-id [0 | 1] key • ip ospf passive • ip ospf priority • ip ospf retransmit-interval • ip ospf transmit-delay For a complete description of these parameters, see the summary of OSPF port parameters in the next section. OSPF interface parameters The following parameters apply to OSPF interfaces . Area Assigns an interface to a specific area. You can assign either an IP address or number to represent an OSPF Area ID. If you assign a number, it can be any value from 0 - 2,147,483,647. Auth-change-wait-time OSPF gracefully implements authentication changes to allow all routers to implement the change and thus prevent disruption to neighbor adjacencies. During the authentication-change interval, both the old and new authentication information is supported. The default authentication-change interval is 300 seconds (5 minutes). You change the interval to a value from 0 - 14400 seconds. Authentication-key OSPF supports three methods of authentication for each interface-none, simple password, and MD5. Only one method of authentication can be active on an interface at a time. The default authentication value is none, meaning no authentication is performed. • The simple password method of authentication requires you to configure an alphanumeric password on an interface. The simple password setting takes effect immediately. All OSPF packets transmitted on the interface contain this password. Any OSPF packet received on the interface is checked for this password. If the password is not present, then the packet is dropped. The password can be up to eight characters long. • The MD5 method of authentication requires you to configure a key ID and an MD5 Key. The key ID is a number from 1 - 255 and identifies the MD5 key that is being used. The MD5 key can be up to sixteen alphanumeric characters long. Cost Indicates the overhead required to send a packet across an interface. You can modify the cost to differentiate between 100 Mbps, 1Gbps, and 10 Gbps. The default cost is calculated by dividing 100 million by the bandwidth. For 10 Mbps links, the cost is 10. The cost for 100 Mbps, 1Gbps, and 10 Gbps links is 1, because the speed of 100 Mbps and 10Gbps was not in use at the time the OSPF cost formula was devised. Dead-interval Indicates the number of seconds that a neighbor router waits for a hello packet from the current router before declaring the router down. The value can be from 1 - 65535 seconds. By default, the dead timer interval is four times the hello timer interval. The default is 40 seconds. Hello-interval Represents the length of time between the transmission of hello packets. The value can be from 1 - 65535 seconds. The default is 10 seconds. On NBMA, the default is 30 seconds. 692 BigIron RX Series Configuration Guide 53-1002253-01