Dell PowerConnect J-8216 Software Guide for JUNOS version 10.3 - Page 1855

Chapter 74: Operational Commands for Layer 3 Protocols show ospf neighbor detail on page 1784 show ospf neighbor extensive on page 1785 show ospf3 neighbor detail on page 1786 show ospf neighbor area area-id on page 1786 show ospf neighbor interface interface-name on page 1786 show ospf3 neighbor instance all (OSPFv3 Multiple Family Address Support Enabled) on page 1786 Output Fields Table 206 on page 1783 lists the output fields for the show (ospf | ospf3) neighbor command. Output fields are listed in the approximate order in which they appear. Table 206: show (ospf | ospf3) neighbor Output Fields Field Name Field Description Level of Output Address Address of the neighbor. All levels Interface Interface through which the neighbor is reachable. All levels State ID State of the neighbor: All levels • Attempt-Valid only for neighbors attached to nonbroadcast networks. It indicates that no recent information has been received from the neighbor, but that a more concerted effort must be made to contact the neighbor. • Down-Initial state of a neighbor conversation. It indicates that no recent information has been received from the neighbor. Hello packets might continue to be sent to neighbors in the Down state, although at a reduced frequency. • Exchange-Routing device is describing its entire link-state database by sending database description packets to the neighbor. Each packet has a sequence number and is explicitly acknowledged. • ExStart-First step in creating an adjacency between the two neighboring routing devices. The goal of this step is to determine which routing device is the master, and to determine the initial sequence number. • Full-Neighboring routing devices are fully adjacent. These adjacencies appear in router link and network link advertisements. • Init-A Hello packet has recently been sent by the neighbor. However, bidirectional communication has not yet been established with the neighbor. This state may occur, for example, because the routing device itself did not appear in the neighbor's hello packet. • Loading-Link-state request packets are sent to the neighbor to acquire more recent advertisements that have been discovered (but not yet received) in the Exchange state. • 2Way-Communication between the two routing devices is bidirectional. This state has been ensured by the operation of the Hello Protocol. This is the most advanced state short of beginning adjacency establishment. The (backup) designated router is selected from the set of neighbors in state 2Way or greater. Router ID of the neighbor. All levels Pri Priority of the neighbor to become the designated router. All levels Dead Number of seconds until the neighbor becomes unreachable. All levels 1783