Dell PowerConnect J-8216 Software Guide for JUNOS version 10.3 - Page 2002

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS Table 241: show route detail Output Fields (continued) Field Name Field Description Announcement bits List of protocols that announce this route. n-Resolve inet indicates that the route is used for route resolution for next hops found in the routing table. n is an index used by Dell Support only (see "Requesting Technical Support" on page lxxi). AS path VC Label AS path through which the route was learned. The letters at the end of the AS path indicate the path origin, providing an indication of the state of the route at the point at which the AS path originated: • I-IGP. • E-EGP. • ?-Incomplete; typically, the AS path was aggregated. When AS path numbers are included in the route, the format is as follows: • [ ]-Brackets enclose the number that precedes the AS path. This number represents the number of ASs present in the AS path, when calculated as defined in RFC 4271. This value is used in the AS-path merge process, as defined in RFC 4893. • [ ]-If more than one AS number is configured on the routing device, or if AS path prepending is configured, brackets enclose the local AS number associated with the AS path. • { }-Braces enclose AS sets, which are groups of AS numbers in which the order does not matter. A set commonly results from route aggregation. The numbers in each AS set are displayed in ascending order. • ( )-Parentheses enclose a confederation Parentheses and brackets enclose a confederation set. MPLS label assigned to the Layer 2 circuit virtual connection. MTU Maximum transmission unit (MTU) of the Layer 2 circuit. VLAN ID VLAN identifier of the Layer 2 circuit. Prefixes bound to route Forwarding Equivalent Class (FEC) bound to this route. Applicable only to routes installed by LDP. Communities Community path attribute for the route. See Table 244 on page 1934 for all possible values for this field. Layer2-info: encaps Layer 2 encapsulation (for example, VPLS). control flags Control flags: none or Site Down. mtu Maximum transmission unit (MTU) information. Label-Base, range First label in a block of labels and label block size. A remote PE routing device uses this first label when sending traffic toward the advertising PE routing device. status vector Layer 2 VPN and VPLS network layer reachability information (NLRI). Localpref Local preference value included in the route. Router ID BGP router ID as advertised by the neighbor in the open message. 1930