Dell PowerConnect J-8216 Software Guide for JUNOS version 10.3 - Page 2022

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS Table 246: show route extensive Output Fields (continued) Field Name Field Description AS path AS path through which the route was learned. The letters at the end of the AS path indicate the path origin, providing an indication of the state of the route at the point at which the AS path originated: • I-IGP. • E-EGP. • ?-Incomplete; typically, the AS path was aggregated. When AS path numbers are included in the route, the format is as follows: • [ ]-Brackets enclose the local AS number associated with the AS path if more than one AS number is configured on the routing device, or if AS path prepending is configured. • { }-Braces enclose AS sets, which are groups of AS numbers in which the order does not matter. A set commonly results from route aggregation. The numbers in each AS set are displayed in ascending order. • ( )-Parentheses enclose a confederation Parentheses and brackets enclose a confederation set. AS path: I (For route reflected output only) Originator ID attribute set by the route reflector. VC Label MPLS label assigned to the Layer 2 circuit virtual connection. MTU Maximum transmission unit (MTU) of the Layer 2 circuit. VLAN ID VLAN identifier of the Layer 2 circuit. Cluster list (For route reflected output only) Cluster ID sent by the route reflector. Originator ID (For route reflected output only) Address of router that originally sent the route to the route reflector. Prefixes bound to route Forwarding Equivalent Class (FEC) bound to this route. Applicable only to routes installed by LDP. Communities Community path attribute for the route. See the Output Field table in the show route detail command for all possible values for this field. Layer2-info: encaps Layer 2 encapsulation (for example, VPLS). control flags Control flags: none or Site Down. mtu Maximum transmission unit (MTU) information. Label-Base, range First label in a block of labels and label block size. A remote PE routing device uses this first label when sending traffic toward the advertising PE routing device. status vector Layer 2 VPN and VPLS network layer reachability information (NLRI). Localpref Local preference value included in the route. Router ID BGP router ID as advertised by the neighbor in the open message. 1950