Dell PowerConnect J-8216 Software Guide for JUNOS version 10.3 - Page 3383

Chapter 128: SNMP Table 443: SNMP Configuration Page (continued) Field Function Your Action Categories Targets Specifies which trap categories are added to the trap group being configured. • To generate traps for authentication failures, select Authentication. • To generate traps for chassis and environment notifications, select Chassis. • To generate traps for configuration changes, select Configuration. • To generate traps for link-related notifications (up-down transitions), select Link. • To generate traps for remote operation notifications, select Remote operations. • To generate traps for remote network monitoring (RMON), select RMON alarm. • To generate traps for routing protocol notifications, select Routing. • To generate traps on system warm and cold starts, select Startup. • To generate traps on Virtual Router Redundancy Protocol (VRRP) events (such as new-master or authentication failures), select VRRP events. Specifies one or more hostnames or IP addresses for the systems to receive SNMP traps generated by the trap group being configured. 1. Enter the hostname or IP address, in dotted decimal notation, of the target system to receive the SNMP traps. 2. Click Add. Health Monitoring Enable Health Monitoring Interval Enables the SNMP health monitor on the switch. The health monitor periodically (over the time you specify in the interval field) checks the following key indicators of switch health: • Percentage of file storage used • Percentage of Routing Engine CPU used • Percentage of Routing Engine memory used • Percentage of memory used for each system process • Percentage of CPU used by the forwarding process • Percentage of memory used for temporary storage by the forwarding process Select the check box to enable the health monitor and configure options. Clear the check box to disable the health monitor. NOTE: If you select the Enable Health Monitoring check box and do not specify options, then SNMP health monitoring is enabled with default values. Specifies the sampling frequency, in seconds, over which the key health indicators are sampled and compared with the rising and falling thresholds. For example, if you configure the interval as 100 seconds, the values are checked every 100 seconds. Enter an interval time, in seconds, from 1 through 2147483647. The default value is 300 seconds (5 minutes). 3311