Dell PowerEdge 1650 Rack Installation Guide - Page 11
Installing the RapidRails Slide Assemblies
View all Dell PowerEdge 1650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
2 Place a mark 44 mm (1.75 inches) above the original mark you made (or count up three holes in a rack that meets EIA-310 standards) and mark the rack's front vertical rails with a felt-tipped marker or masking tape (if you counted holes, place a mark just above the top hole). This mark or piece of tape indicates where the system's upper edge will be located on the vertical rails (see Figure 1-4). Figure 1-4. Marking the Vertical Rails tape on vertical rail Installing the RapidRails Slide Assemblies 1 At the front of the rack cabinet, position one of the RapidRails slide assemblies so that its mounting-bracket flange fits between the marks or tape you placed on the rack (see Figure 1-5). The mounting hook on the slide assembly's front mounting bracket flange should enter the top hole between the marks you made on the vertical rails. 2 Push the slide assembly forward until the mounting hook enters its respective square hole on the vertical rail, and then push down on the mounting-bracket flange until the mounting hooks seat in the square holes and the push button pops out and clicks. Rack Installation Guide 1-7