Dell PowerEdge 1650 Rack Installation Guide - Page 28
Holding the left slide assembly into position in the rack at the location you marked
View all Dell PowerEdge 1650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
www.dell.com | support.dell.com 8 Holding the left slide assembly into position in the rack at the location you marked, adjust the extended rear bracket tightly against the back of the vertical two-post rack and secure it to the rail with two 12-24 x 0.5-inch Phillips screws (see Figure 1-18). Figure 1-18. Installing the Slide Assemblies for Flush-Mount Configuration two-post open-frame rack joined bracket 12-24 x 0.5-inch panhead Phillips screw (4 each slide) shoulder screw on system system release latch slide assembly slide release latch 9 Secure the front bracket on the slide assembly to the two-post rail with two 12-24 x 0.5-inch pan-head Phillips screws (see Figure 1-18). 10 Repeat step 8 and step 9 to install the right slide assembly in the rack. 11 Use an 11/32-inch wrench or nut driver to fully tighten the nuts on the mounting brackets on both slide assemblies that you tightened with your fingers. 1-24 Rack Installation Guide