Dell PowerEdge 1650 Rack Installation Guide - Page 16
Push the tab on the back end of the cable-management arm into the latch on the end
View all Dell PowerEdge 1650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
www.dell.com | support.dell.com To install the cable-management arm on the back of the system, perform the following steps: 1 Facing the back of the rack cabinet, locate the latch on the end of the right slide assembly that you secured to the back vertical rail. 2 Push the tab on the back end of the cable-management arm into the latch on the end of the slide assembly (see Figure 1-8). The latch clicks when locked. 3 Push the tab on the front end of the cable-management arm into a mating latch on the inner segment of the slide assembly (see Figure 1-8). The latch clicks when locked. Figure 1-8. Installing the Cable-Management Arm tab on front end tab on back end latch on end of slide assembly latch on inner segment of slide assembly cable-management arm 1-12 Rack Installation Guide stop block