Dell PowerEdge M420 Dell PowerEdge M520 Systems Owner's Manual - Page 52
Storage Controller Card, Removing The Storage Controller Card
View all Dell PowerEdge M420 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Figure 19. Replacing the NVRAM Backup Battery 1. positive side of battery 2. negative side of battery connector Storage Controller Card Your system includes a dedicated expansion-card slot on the blade system board for the storage controller card that provides the integrated storage subsystem for your system's hard drives. The storage controller card supports SAS and SATA hard drives. NOTE: The storage controller card is located underneath the drive bays. Removing The Storage Controller Card CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. CAUTION: To ensure proper system cooling, a storage controller blank must be installed on the storage controller card connector that is not occupied. Remove the storage controller blank only if you intend to install a storage controller card. 1. Remove the blade from the enclosure. 2. Open the blade. 3. Remove the blade system board and place it on the work surface. 4. Remove the two screws from the storage controller card. 5. Pull the storage controller card straight up and out of the connector. 52