Dell PowerStore 1200T EMC PowerStore Networking Guide for PowerStore T Models - Page 68
Con NVMe/TCP network on the ToR switches
View all Dell PowerStore 1200T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
Table 27. Code sample for configuring ToR switches for iSCSI network Switch 1 Switch 2 configure terminal interface vlan 200 description iSCSI_Network no shutdown exit interface ethernet 1/1/7 description NodeA_IO_0_port_2 no shutdown switchport mode trunk switchport trunk allowed vlan 200 mtu 9216 exit interface port-channel 50 switchport trunk allowed vlan 200 exit configure terminal interface vlan 200 description iSCSI_Network no shutdown exit interface ethernet 1/1/48 description NodeB_IO_0_port_2 no shutdown switchport mode trunk switchport trunk allowed vlan 200 mtu 9216 exit interface port-channel 50 switchport trunk allowed vlan 200 exit Configure NVMe/TCP network on the ToR switches The following steps use the resources from the example used in this document. If you did not use the same resources, see your completed Network Preparation Worksheet for Storage services. 1. Establish a terminal connection to the first ToR switch (Switch1). 2. Enter global configuration mode. configure terminal 3. Create the NVMe/TCP VLAN. interface vlan 300 description NVMe_Network no shutdown exit 4. Configure NVMe/TCP VLAN for Node A ports interface ethernet 1/1/5 description NodeA_IO_0_port_0 no shutdown switchport mode trunk switchport trunk allowed vlan 300 mtu 9216 exit 5. Configure the NVMe/TCP VLAN on the uplinks interface port-channel 50 switchport trunk allowed vlan 300 exit 6. Repeat steps 3 - 5 for each NVMe/TCP network you are creating. 7. Repeat steps 1 - 6 on the second ToR switch (Switch2) as demonstrated below. NOTE: Be sure to use the correct ethernet ports when configuring the second ToR switch (Switch2) 68 Configuring PowerStore T model with Dell PowerSwitch Series S4148 Top-of-Rack switches