Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.100.0 - Page 106

Example of Permitting All Packets from a Specified Host In this first example, TCP packets from host 10.1.1.1 with TCP destination port equal to 24 are permitted. All others are denied. Dell(conf)#ip access-list extended ABC Dell(conf-ext-nacl)#permit tcp host 10.1.1.1 any eq 24 Dell(conf-ext-nacl)#deny ip any any fragment Dell(conf-ext-nacl) Example of Permitting Only First Fragments and Non-Fragmented Packets from a Specified Host In the following example, the TCP packets that are first fragments or non-fragmented from host 10.1.1.1 with TCP destination port equal to 24 are permitted. Additionally, all TCP non-first fragments from host 10.1.1.1 are permitted. All other IP packets that are non-first fragments are denied. Dell(conf)#ip access-list extended ABC Dell(conf-ext-nacl)#permit tcp host 10.1.1.1 any eq 24 Dell(conf-ext-nacl)#permit tcp host 10.1.1.1 any fragment Dell(conf-ext-nacl)#deny ip any any fragment Dell(conf-ext-nacl) Example of Logging Denied Packets To log all the packets denied and to override the implicit deny rule and the implicit permit rule for TCP/ UDP fragments, use a configuration similar to the following. Dell(conf)#ip access-list extended ABC Dell(conf-ext-nacl)#permit tcp any any fragment Dell(conf-ext-nacl)#permit udp any any fragment Dell(conf-ext-nacl)#deny ip any any log Dell(conf-ext-nacl) When configuring ACLs with the fragments keyword, be aware of the following. When an ACL filters packets, it looks at the fragment offset (FO) to determine whether it is a fragment. • FO = 0 means it is either the first fragment or the packet is a non-fragment. • FO > 0 means it is dealing with the fragments of the original packet. Configure a Standard IP ACL To configure an ACL, use commands in IP ACCESS LIST mode and INTERFACE mode. For a complete list of all the commands related to IP ACLs, refer to the Dell Networking OS Command Line Interface Reference Guide. To set up extended ACLs, refer to Configure an Extended IP ACL. A standard IP ACL uses the source IP address as its match criterion. 1 Enter IP ACCESS LIST mode by naming a standard IP access list. CONFIGURATION mode ip access-list standard access-listname 2 Configure a drop or forward filter. CONFIG-STD-NACL mode seq sequence-number {deny | permit} {source [mask] | any | host ip-address} [count [byte] [dscp] [order] [fragments] NOTE: When assigning sequence numbers to filters, keep in mind that you might need to insert a new filter. To prevent reconfiguring multiple filters, assign sequence numbers in multiples of five. To view the rules of a particular ACL configured on a particular interface, use the show ip accounting access-list ACL-name interface interface command in EXEC Privilege mode. 106 Access Control Lists (ACLs)