Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.100.0 - Page 584

Dell(conf-if-te-2/2)#ip ospf dead-interval 80 Dell(conf-if-te-2/2)# In the following example, the dead interval is set at 4x the hello interval (shown in bold). Dell (conf-if-te-2/2)#ip ospf dead-interval 20 Dell (conf-if-te-2/2)#do show ip os int tengigabitethernet 1/3 TenGigabitEthernet 2/2 is up, line protocol is up Internet Address 20.0.0.1/24, Area 0 Process ID 10, Router ID 1.1.1.2, Network Type BROADCAST, Cost: 1 Transmit Delay is 1 sec, State DR, Priority 1 Designated Router (ID) 1.1.1.2, Interface address 30.0.0.1 Backup Designated Router (ID) 1.1.1.1, Interface address 30.0.0.2 Timer intervals configured, Hello 20, Dead 80, Wait 20, Retransmit 5 Hello due in 00:00:04 Neighbor Count is 1, Adjacent neighbor count is 1 Adjacent with neighbor 1.1.1.1 (Backup Designated Router) Dell (conf-if-te-2/2)# Configuration Information The interfaces must be in Layer 3 mode (assigned an IP address) and enabled so that they can send and receive traffic. The OSPF process must know about these interfaces. To make the OSPF process aware of these interfaces, they must be assigned to OSPF areas. You must configure OSPF GLOBALLY on the system in CONFIGURATION mode. NOTE: Loop back routes are not installed in the Route Table Manager (RTM) as non-active routes. OSPF features and functions are assigned to each router using the CONFIG-INTERFACE commands for each interface. NOTE: By default, OSPF is disabled. Configuration Task List for OSPFv2 (OSPF for IPv4) You can perform the following tasks to configure Open Shortest Path First version 2 (OSPF for IPv4) on the switch. Two of the tasks are mandatory; others are optional. The following configuration tasks include two mandatory tasks and several optional tasks: • Enabling OSPFv2 (mandatory) • Assigning a Router ID • Assigning an OSPFv2 Area (mandatory) • Enable OSPFv2 on Interfaces • Configuring Stub Areas • Enabling Passive Interfaces • Enabling Fast-Convergence • Changing OSPFv2 Parameters on Interfaces • Enabling OSPFv2 Authentication • Creating Filter Routes • Applying Prefix Lists • Redistributing Routes • Troubleshooting OSPFv2 1 Configure a physical interface. Assign an IP address, physical or Loopback, to the interface to enable Layer 3 routing. 2 Enable OSPF globally. Assign network area and neighbors. 3 Add interfaces or configure other attributes. 4 Set the time interval between when the switch receives a topology change and starts a shortest path first (SPF) calculation. 584 Open Shortest Path First (OSPFv2 and OSPFv3)