Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.100.0 - Page 828

redundancy force-failover stack-unit A new standby is elected. When the former stack master comes back online, it becomes a member unit. • Prevent the stack master from rebooting after a failover. CONFIGURATION mode redundancy disable-auto-reboot stack-unit This command does not affect a forced failover, manual reset, or a stack-link disconnect. • Display redundancy information. EXEC Privilege mode show redundancy Resetting a Unit on a Stack You may reset any stack unit except for the master management unit, as shown in the following message. % Error: Reset of master unit is not allowed. To rest a unit on a stack, use the following commands. • Reload a stack-unit. EXEC Privilege mode reset stack-unit unit-number • Reload a member unit, from the unit itself. EXEC Privilege mode reset-self • Reset a stack-unit when the unit is in a problem state. EXEC Privilege mode reset stack-unit unit-number {hard} Verify a Stack Configuration The light of the LED status indicator on the front panel of the stack identifies the unit's role in the stack. • Off indicates the unit is a stack member. • Blinking green indicates the unit is the stack standby. • Solid green indicates the unit is the stack master (management unit). Displaying the Status of Stacking Ports To display the status of the stacking ports, including the topology, use the following command. • Display the stacking ports. EXEC Privilege mode show system stack-ports Examples of Viewing the Status for Stacked Switches Dell#show system stack-ports Topology: Ring Interface Connection Link Speed Admin Link (Gb/s) Status Status Group Trunk 828 Stacking