Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.100.0 - Page 372

switchport channel-member TenGigabitEthernet 1/6 Dell(conf-if-portch)#int Te 1/6 Dell(conf-if)#ip address 10.56.4.4 /24 % Error: Port is part of a LAG Te 1/6. Dell(conf-if)# Reassigning an Interface to a New Port Channel An interface can be a member of only one port channel. If the interface is a member of a port channel, remove it from the first port channel and then add it to the second port channel. Each time you add or remove a channel member from a port channel, Dell Networking OS recalculates the hash algorithm for the port channel. To reassign an interface to a new port channel, use the following commands. 1 Remove the interface from the first port channel. INTERFACE PORT-CHANNEL mode no channel-member interface 2 Change to the second port channel INTERFACE mode. INTERFACE PORT-CHANNEL mode interface port-channel id number 3 Add the interface to the second port channel. INTERFACE PORT-CHANNEL mode channel-member interface Example of Moving an Interface to a New Port Channel The following example shows moving an interface from port channel 4 to port channel 3. Dell(conf-if-po-4)#show config ! interface Port-channel 4 no ip address channel-member TenGigabitEthernet 1/8 no shutdown Dell(conf-if-po-4)#no chann tengi 1/8 Dell(conf-if-po-4)#int port 3 Dell(conf-if-po-3)#channel tengi 1/8 Dell(conf-if-po-3)#sho conf ! interface Port-channel 3 no ip address channel-member TenGigabitEthernet 1/8 shutdown Dell(conf-if-po-3)# Configuring the Minimum Oper Up Links in a Port Channel You can configure the minimum links in a port channel (LAG) that must be in "oper up" status to consider the port channel to be in "oper up" status. To set the "oper up" status of your links, use the following command. • Enter the number of links in a LAG that must be in "oper up" status. INTERFACE mode minimum-links number The default is 1. 372 Interfaces