Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.100.0 - Page 52

Dell# show feature Example of show feature output For a particular target where VRF is enabled, the show output is similar to the following: Feature State VRF Enabled View Command History The command-history trace feature captures all commands entered by all users of the system with a time stamp and writes these messages to a dedicated trace log buffer. The system generates a trace message for each executed command. No password information is saved to the file. To view the command-history trace, use the show command-history command. Example of the show command-history Command Dell#show command-history [12/5 10:57:8]: CMD-(CLI):service password-encryption [12/5 10:57:12]: CMD-(CLI):hostname Force10 [12/5 10:57:12]: CMD-(CLI):ip telnet server enable [12/5 10:57:12]: CMD-(CLI):line console 0 [12/5 10:57:12]: CMD-(CLI):line vty 0 9 [12/5 10:57:13]: CMD-(CLI):boot system rpm0 primary flash://FTOS-CB-1.1.1.2E2.bin Upgrading Dell Networking OS NOTE: To upgrade Dell Networking Operating System (OS), refer to the Release Notes for the version you want to load on the system. Using HTTP for File Transfers Stating with Release 9.3(0.1), you can use HTTP to copy files or configuration details to a remote server. To transfer files to an external server, use the copy source-file-url http://host[:port]/file-path command. Enter the following source-file-url keywords and information: • To copy a file from the internal FLASH, enter flash:// followed by the filename. • To copy the running configuration, enter the keyword running-config. • To copy the startup configuration, enter the keyword startup-config. • To copy a file on the USB device, enter usbflash:// followed by the filename. In the Dell Networking OS release 9.8(0.0), HTTP services support the VRF-aware functionality. If you want the HTTP server to use a VRF table that is attached to an interface, configure that HTTP server to use a specific routing table. You can use the ip http vrf command to inform the HTTP server to use a specific routing table. After you configure this setting, the VRF table is used to look up the destination address. NOTE: To enable HTTP to be VRF-aware, as a prerequisite you must first define the VRF. You can specify either the management VRF or a nondefault VRF to configure the VRF awareness setting. When you specify the management VRF, the copy operation that is used to transfer files to and from an HTTP server utilizes the VRF table corresponding to the Management VRF to look up the destination. When you specify a nondefault VRF, the VRF table corresponding to that nondefault VRF is used to look up the HTTP server. However, these changes are backward-compatible and do not affect existing behavior; meaning, you can still use the ip http sourceinterface command to communicate with a particular interface even if no VRF is configured on that interface 52 Getting Started