Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.100.0 - Page 972

Figure 142. VRRP for IPv6 Topology NOTE: This example does not contain comprehensive directions and is intended to provide guidance for only a typical VRRP configuration. You can copy and paste from the example to your CLI. Be sure you make the necessary changes to support your own IP addresses, interfaces, names, and so on. NOTE: In a VRRP or VRRPv3 group, if two routers come up with the same priority and another router already has MASTER status, the router with master status continues to be master even if one of two routers has a higher IP or IPv6 address. Router 2 R2(conf)#interface tengigabitethernet 1/1 R2(conf-if-te-1/1)#no ip address R2(conf-if-te-1/1)#ipv6 address 1::1/64 R2(conf-if-te-1/1)#vrrp-group 10 NOTE: You must configure a virtual link local (fe80) address for each VRRPv3 group created for an interface. The VRRPv3 group becomes active as soon as you configure the link local address. Afterwards, you can configure the group's virtual IPv6 address. R2(conf-if-te-1/1-vrid-10)#virtual-address fe80::10 NOTE: The virtual IPv6 address you configure should be the same as the IPv6 subnet to which the interface belongs. R2(conf-if-te-1/1-vrid-10)#virtual-address 1::10 R2(conf-if-te-1/1-vrid-10)#no shutdown 972 Virtual Router Redundancy Protocol (VRRP)