Dell PowerSwitch S4820T 9.50.1 Configuration Guide for the S4820T System - Page 246

CAM Allocation Openflow fedgovacl Setting 0 0 The following additional CAM allocation settings are supported on the S6000, S4810 or S4820T platforms only. Table 11. Additional Default CAM Allocation Settings Additional CAM Allocation FCoE ACL (fcoeacl) ISCSI Opt ACL (iscsioptacl) Setting 0 0 The ipv6acl and vman-dual-qos allocations must be entered as a factor of 2 (2, 4, 6, 8, 10). All other profile allocations can use either even or odd numbered ranges. NOTE: Can be only one odd number of Blocks in the CLI configuration; the other Blocks must be in factors of 2. For example, a CLI configuration of 5+4+2+1+1 Blocks is not supported; a configuration of 6+4+2+1 Blocks is supported. You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload the system for the new settings to take effect. CAM Allocation for Ingress Use the cam-acl-egress command to allocate the space for egress L2, IPV4 and IPV6 ACL. The total number of available FP blocks is 4. Allocate atleast one group of L2ACL and IPV4 ACL. Dell(conf)#do show cam-acl-egress -- Chassis Egress Cam ACL -- Current Settings(in block sizes) 1 block = 256 entries L2Acl : 1 Ipv4Acl : 1 Ipv6Acl : 2 -- Stack unit 0 -- Current Settings(in block sizes) L2Acl : 1 Ipv4Acl : 1 Ipv6Acl : 2 -- Stack unit 7 -- Current Settings(in block sizes) L2Acl : 1 Ipv4Acl : 1 Ipv6Acl : 2 Dell(conf)# 1. Select a cam-acl action. CONFIGURATION mode cam-acl [default | l2acl] 246 Content Addressable Memory (CAM)