Dell PowerSwitch S4820T 9.50.1 Configuration Guide for the S4820T System - Page 804

Dell#show running-config Current Configuration ... ! hostname Force10 ! enable password level 8 notjohn enable password Force10 ! username admin password 0 admin username john password 0 john privilege 8 ! The following example shows the Telnet session for user john. The show privilege command output confirms that john is in privilege level 8. In EXEC Privilege mode, john can access only the commands listed. In CONFIGURATION mode, john can access only the snmp-server commands. apollo% telnet 172.31.1.53 Trying 172.31.1.53... Connected to 172.31.1.53. Escape character is '^]'. Login: john Password: Dell#show priv Current privilege level is 8 Dell#? configure Configuring from terminal disable Turn off privileged commands enable Turn on privileged commands exit Exit from the EXEC no Negate a command show Show running system information terminal Set terminal line parameters traceroute Trace route to destination Dell#confi Dell(conf)#? end Exit from Configuration mode exit Exit from Configuration mode no Reset a command snmp-server Modify SNMP parameters Dell(conf)# Specifying LINE Mode Password and Privilege You can specify a password authentication of all users on different terminal lines. The user's privilege level is the same as the privilege level assigned to the terminal line, unless a more specific privilege level is assigned to the user. To specify a password for the terminal line, use the following commands. • Configure a custom privilege level for the terminal lines. LINE mode privilege level level - level level: The range is from 0 to 15. Levels 0, 1, and 15 are pre-configured. Levels 2 to 14 are available for custom configuration. • Specify either a plain text or encrypted password. LINE mode password [encryption-type] password 804 Security