Dell PowerSwitch S4820T 9.50.1 Configuration Guide for the S4820T System - Page 828

• If you inherit a user role, you cannot modify or delete the inheritance. If you want to change or remove the inheritance, delete the user role and create it again. If the user role is in use, you cannot delete the user role. 1. Create a new user role CONFIGURATION mode userrole name [inherit existing-role-name] 2. Verify that the new user role has inherited the security administrator permissions. Dell(conf)#do show userroles EXEC Privilege mode 3. After you create a user role, configure permissions for the new user role. See Modifying Command Permissions for Roles. Example of Creating a User Role The configuration in the following example creates a new user role, myrole, which inherits the security administrator (secadmin) permissions. Create a new user role, myrole and inherit security administrator permissions. Dell(conf)#userrole myrole inherit secadmin Verify that the user role, myrole, has inherited the security administrator permissions. The output highlighted in bold indicates that the user role has successfully inherited the security administrator permissions. Dell(conf)#do show userroles Mon Apr 28 14:46:25 PDT 2014 Authorization Mode: role or privilege Role Inheritance Modes netoperator netadmin secadmin sysadmin Protocol MAC. myrole secadmin Exec Config Interface Router IP Route-map Protocol MAC Exec Config Line Exec Config Interface Line Router IP Route-map Exec Config Line Modifying Command Permissions for Roles You can modify (add or delete) command permissions for newly created user roles and system defined roles using the role mode { { { addrole | deleterole } role-name } | reset } command command in Configuration mode. NOTE: You cannot modify system administrator command permissions. If you add or delete command permissions using the role command, those changes only apply to the specific user role. They do not apply to other roles that have inheritance from that role. Authorization and accounting only apply to the roles specified in that configuration. 828 Security