Dell PowerSwitch S4820T 9.50.1 Configuration Guide for the S4820T System - Page 416

• Enter the slot and the port (0) to configure a Management interface. CONFIGURATION mode interface managementethernet interface The slot range is 0. • Configure an IP address and mask on a Management interface. INTERFACE mode ip address ip-address mask - ip-address mask: enter an address in dotted-decimal format (A.B.C.D). The mask must be in / prefix format (/x). Configuring Management Interfaces on the S-Series You can manage the S-Series from any port. To configure an IP address for the port, use the following commands. There is no separate management routing table, so configure all routes in the IP routing table (the ip route command). • Configure an IP address. INTERFACE mode ip address • Enable the interface. INTERFACE mode no shutdown • The interface is the management interface. INTEFACE mode description Example of the show interface and show ip route Commands To display the configuration for a given port, use the show interface command in EXEC Privilege mode, as shown in the following example. To display the routing table, use the show ip route command in EXEC Privilege mode. Dell#show int gig 0/48 GigabitEthernet 0/48 is up, line protocol is up Description: This is the Managment Interface Hardware is Force10Eth, address is 00:01:e8:cc:cc:ce Current address is 00:01:e8:cc:cc:ce Pluggable media not present Interface index is 46449666 Internet address is 10.11.131.240/23 [output omitted] Dell#show ip route Codes: C - connected, S - static, R - RIP, B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated, O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2, E1 - OSPF external type 1, E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default, > - non-active route, + - summary route 416 Interfaces