Dell PowerSwitch S4820T 9.50.1 Configuration Guide for the S4820T System - Page 537

• If a LAG that is part of a failover group is deleted, the failover group is deleted. • If a LAG moves to the Down state due to this feature, its members may still be in the Up state. LACP Basic Configuration Example The screenshots in this section are based on the following example topology. Two routers are named ALPHA and BRAVO, and their hostname prompts reflect those names. Figure 60. LACP Basic Configuration Example Configure a LAG on ALPHA The following example creates a LAG on ALPHA. Example of Configuring a LAG Alpha(conf)#interface port-channel 10 Alpha(conf-if-po-10)#no ip address Alpha(conf-if-po-10)#switchport Alpha(conf-if-po-10)#no shutdown Alpha(conf-if-po-10)#show config ! interface Port-channel 10 no ip address switchport no shutdown ! Alpha(conf-if-po-10)# Example of Viewing a LAG Port Configuration The following example inspects a LAG port configuration on ALPHA. Alpha#sh int gig 2/31 GigabitEthernet 2/31 is up, line protocol is up Port is part of Port-channel 10 Hardware is Force10Eth, address is 00:01:e8:06:95:c0 Current address is 00:01:e8:06:95:c0 Interface Index is 109101113 Port will not be disabled on partial SFM failure Internet address is not set MTU 1554 bytes, IP MTU 1500 bytes LineSpeed 1000 Mbit, Mode full duplex, Slave Flowcontrol rx on tx on Link Aggregation Control Protocol (LACP) 537