Dell PowerSwitch S4820T 9.50.1 Configuration Guide for the S4820T System - Page 873

SNMP OID %RPM0-P:CP %SNMP-4-RMON_HC_RISING_THRESHOLD: threshold alarm from SNMP OID STACKUNIT0 high-capacity rising Copy Configuration Files Using SNMP To do the following, use SNMP from a remote client. • copy the running-config file to the startup-config file • copy configuration files from the Dell Networking system to a server • copy configuration files from a server to the Dell Networking system You can perform all of these tasks using IPv4 or IPv6 addresses. The examples in this section use IPv4 addresses; however, you can substitute IPv6 addresses for the IPv4 addresses in all of the examples. The following table lists the relevant MIBs for these functions are. Table 68. MIB Objects for Copying Configuration Files via SNMP MIB Object copySrcFileType OID . 1.3.6.1.4.1.6027.3.5.1.1.1. 1.2 Object Values 1 = Dell Networking OS file 2 = running-config 3 = startup-config Description Specifies the type of file to copy from. The range is: • If copySrcFileType is running-config or startup-config, the default copySrcFileLocation is flash. • If copySrcFileType is a binary file, you must also specify copySrcFileLocation and copySrcFileName. copySrcFileLocation . 1.3.6.1.4.1.6027.3.5.1.1.1. 1.3 1 = flash 2 = slot0 3 = tftp 4 = ftp 5 = scp 6 = usbflash Specifies the location of source file. • If copySrcFileLocation is FTP or SCP, you must specify copyServerAddress, copyUserName, and copyUserPassword. copySrcFileName . Path (if the file is not in 1.3.6.1.4.1.6027.3.5.1.1.1. the current directory) 1.4 and filename. Specifies name of the file. • If copySourceFileType is set to runningconfig or startupconfig, Simple Network Management Protocol (SNMP) 873