Dell PowerSwitch S4820T 9.50.1 Configuration Guide for the S4820T System - Page 684

Applying a Redirect-list to an Interface Example: Dell(conf-if-te-2/0)#ip redirect-group xyz Dell(conf-if-te-2/0)# Applying a Redirect-list to an Interface Example: Dell(conf-if-te-1/0)#ip redirect-group test Dell(conf-if-te-1/0)#ip redirect-group xyz Dell(conf-if-te-1/0)#show config ! interface TenGigabitEthernet 1/0 no ip address ip redirect-group test ip redirect-group xyz shutdown Dell(conf-if-te-1/0)# In addition to supporting multiple redirect-lists in a redirect-group, multiple redirect-groups are supported on a single interface. Dell Networking OS has the capability to support multiple groups on an interface for backup purposes. Show Redirect List Configuration To view the configuration redirect list configuration, use the following command in EXEC mode: Command Syntax Command Mode Purpose show ip redirect-list redirect-list-name EXEC View the redirect list configuration and the associated interfaces. show cam pbr show cam-usage EXEC View the redirect list entries programmed in the CAM. List the redirect list configuration using the show ip redirect-list redirect-list-name command. The noncontiguous mask is displayed in dotted format (x.x.x.x). The contiguous mask is displayed in /x format. Some sample outputs are shown below: Dell#show ip redirect-list xyz IP redirect-list xyz: Defined as: seq 5 redirect 3.3.3.3 ip host 222.1.1.1 host 77.1.1.1 Use the show ip redirect-list (without the list name) to display all the redirect-lists configured on the device. Dell#show ip redirect-list IP redirect-list rcl0: Defined as: seq 5 permit ip 200.200.200.200 200.200.200.200 199.199.199.199 199.199.199.199 seq 10 redirect 1.1.1.2 tcp 234.224.234.234 255.234.234.234 222.222.222.222/24 eq 40 ack, Next-hop reachable (via Te 2/1), ARP resolved Applied interfaces: Te 2/0 684 Policy-based Routing (PBR)