Dell PowerSwitch S4820T 9.50.1 Configuration Guide for the S4820T System - Page 898

Allow each unit to completely boot, and verify that the stack manager detects the unit, then power the next unit. Example of a Syslog Figure 119. Creating a New S4820T Stack In the following example, stack unit is the master management unit, stack unit 2is the standby unit. The cables are connected to each unit. Configure the stack groups on the units in the following order: • Configure the first stack group on unit 1: stack-unit 1 stack-group 13 • Configure the stack groups on unit 2: stack-unit 2 stack-group 14 and stack-unit 2 stack-group 15 • Configure the stack groups on unit 3: stack-unit 3 stack-group 12 and stack-unit 3 stack-group 13 • Configure the stack groups on unit 4: stack-unit 4 stack-group 13 and stack-unit 4 stack-group 14 • Configure the final stack-group on unit 1 to complete the stack: stack-unit 1 stack-group 12 When the stack-group configuration is complete, the system prints a syslog for reload. Dell#configure Dell(conf)#stack-unit 4 stack-group 13 Dell(conf)#02:39:12: %STKUNIT4-M:CP %IFMGR-6-STACK_PORTS_ADDED: Ports Fo 4/52 have been configured as stacking ports. Please save and reload for config to take effect Dell(conf)#stack-unit 4 stack-group 14 Dell(conf)#02:39:15: %STKUNIT4-M:CP %IFMGR-6-STACK_PORTS_ADDED: Ports Fo 4/56 have been configured as stacking ports. Please save and reload for config to take effect Dell(conf)# Dell#02:39:18: %STKUNIT4-M:CP %SYS-5-CONFIG_I: Configured from console Reload each unit in the stack. After the reload is complete, the four units come up as a stack with unit 1 as the management unit, unit 2 as the standby unit, and the remaining units as stack-members. All units in the stack can be accessed from the management unit. To view the stack unit information after the reload, use the show system brief command. Dell#show system brief 898 Stacking