Dell PowerVault MD3000i Hardware Owner's Manual - Page 63
Reinstall the battery cover., Tighten the thumbscrew to secure the battery unit to the controller.
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Figure 3-5. Removing and Installing a RAID Controller Module Backup Battery Unit 3 2 1 1 thumbscrew 2 battery cover 3 battery unit 4 Unscrew the thumbscrew holding the battery unit to the controller module. 5 Disconnect the battery unit from the connector by sliding it towards the back of the controller, then remove it from the controller module. 6 Place the replacement battery unit into the controller module tray and push the battery unit into the connector on the RAID controller circuit board. 7 Tighten the thumbscrew to secure the battery unit to the controller. 8 Reinstall the battery cover. 9 Reinstall the RAID controller module (see "Installing a RAID Controller Module" on page 61). 10 Reset the battery installation date using MD Storage Manager. Installing Enclosure Components 63