Dell PowerVault MD3000i Hardware Owner's Manual - Page 98
Self-Monitoring Analysis and Reporting Technology. Allows physical, SDRAM, serial port, service tag - san array
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
SAN - Storage area network. A configuration of computer and storage systems that incorporate dedicated Fibre Channel connectivity between the computer systems and storage. A SAN bypasses traditional network bottlenecks and supports direct high-speed data transfer between the servers and storage devices. SAN storage may consist of both hard-disk drive and tape storage devices that are connected through switches and bridges to multiple servers. SCSI - Small computer system interface. An I/O bus interface with faster data transmission rates than standard ports. SDRAM - Synchronous dynamic random-access memory. sec - Second(s). serial port - An I/O port used most often to connect a modem to your system. You can usually identify a serial port on your system by its 9-pin connector. service tag - A bar code label on the system used to identify it when you call Dell for technical support. simple disk volume - The volume of free space on a single dynamic, physical disk. SMART - Self-Monitoring Analysis and Reporting Technology. Allows physical disks to report errors and failures to the system BIOS and then display an error message on the screen. SMP - Symmetric multiprocessing. Used to describe a system that has two or more processors connected via a high-bandwidth link and managed by an operating system, where each processor has equal access to I/O devices. SNMP - Simple Network Management Protocol. A standard interface that allows a network manager to remotely monitor and manage workstations. spanning - Spanning, or concatenating, disk volumes combines unallocated space from multiple disks into one logical volume, allowing more efficient use of all the space and all physical disk drive letters on a multiple-disk system. striping - Disk striping writes data across three or more disks in an array, but only uses a portion of the space on each disk. The amount of space used by a "stripe" is the same on each disk used. A virtual disk may use several stripes on the same set of disks in an array. See also guarding, mirroring, and RAID. 98 Glossary