Dell S3100 EMC Command Line Reference Guide for the Series 9.14.1.5 - Page 1752

55 Spanning Tree Protocol (STP) The commands in this section configure and monitor the IEEE 802.1d spanning tree protocol (STP) and are supported on the Dell EMC Networking switch/routing platform. Topics: • bridge-priority • bpdu-destination-mac-address • debug spanning-tree • description • disable • forward-delay • hello-time • max-age • protocol spanning-tree • show config • show spanning-tree 0 • spanning-tree bridge-priority Set the bridge priority of the switch in an IEEE 802.1D spanning tree. Syntax bridge-priority {priority-value | primary | secondary} To return to the default value, use the no bridge-priority command. Parameters priority-value primary secondary Enter a number as the bridge priority value. The range is from 0 to 65535. The default is 32768. Enter the keyword primary to designate the bridge as the root bridge. Enter the keyword secondary to designate the bridge as a secondary root bridge. Defaults Command Modes Command History priority-value = 32768 SPANNING TREE (The prompt is "config-stp".) This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version 9.10(0.1) 9.10(0.0) 9.10(0.0) Description Introduced on the S6010-ON and S4048T-ON. Introduced on the S3148. Introduced on the S6100-ON. 1752 Spanning Tree Protocol (STP)