Dell S3100 EMC Command Line Reference Guide for the Series 9.14.1.5 - Page 694

21 Interfaces To configure egress, port channel, time domain, and UDP, use these interface commands. Topics: • Basic Interface Commands • Egress Interface Selection (EIS) Commands • Port Channel Commands • Time Domain Reflectometer (TDR) Commands • UDP Broadcast Commands Basic Interface Commands The following commands are for Physical, Loopback, and Null interfaces. clear counters Clear the counters displayed in the show interfaces commands for all virtual router redundancy protocol (VRRP) groups, virtual local area networks (VLANs), and physical interfaces, or selected ones. Syntax Parameters clear counters [interface | vrrp {vr-id | ipv6 vr-id} | learning-limit | vlan vlan-id] interface (OPTIONAL) Enter any of the following keywords and the interface information to clear counters from a specified interface: • For IPv4 access-group counters, enter the keyword ip. • For IPv6 access-group counters, enter the keyword ipv6. • For a Loopback interface, enter the keyword loopback then a number from 0 to 16383. • For MAC access-group counters, enter the keyword mac. • For a Port Channel interface, enter the keywords port-channel then a number. • For the management interface, enter the keyword ManagementEthernet then slot/port information. • For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a tunnel interface, enter the keyword tunnel. The range is from 1 to 16383. NOTE: This command also enables you to clear the port configurations corresponding to a range of ports. However, for Open Networking (ON) platforms the notation for specifying port range in the command is different from how you specify in non-ON platforms. 694 Interfaces