Dell S3100 EMC Command Line Reference Guide for the Series 9.14.1.5 - Page 1767

56 Stacking All commands in this chapter are specific to the Dell EMC Networking OS. You can use the commands to pre-configure a switch, so that the configuration settings are invoked when the switch is attached to other S-Series units. For information about using the S-Series stacking feature, see the Stacking S-Series Switches section in the Dell EMC Networking OS Configuration Guide. Topics: • redundancy disable-auto-reboot • redundancy force-failover stack-unit • redundancy protocol • reset stack-unit • show redundancy • show system stack-ports • stack-unit priority • stack-unit provision • upgrade system stack-unit redundancy disable-auto-reboot Prevent the S-Series stack management unit, stack member unit, and standby unit from rebooting if they fail. Syntax redundancy disable-auto-reboot stack-unit [1-6 | members] To return to the default, use the no redundancy disable-auto-reboot stack-unit command. Parameters stack-unit members Enter the stack-unit number. The range is from 1 to 12. Enter the keyword members for all stack-units. Defaults Command Modes Command History Disabled (the failed switch is automatically rebooted). CONFIGURATION This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.10(0.0) 9.10(0.0) 9.8(2.0) Description Introduced on the S3148. Increased the stacking range to 12 units in S3100 series. Introduced on the S6100-ON. Introduced on the S3100 series. Stacking 1767