Dell S3100 EMC Command Line Reference Guide for the Series 9.14.1.5 - Page 204

Example Version 9.0.2.0 8.3.11.1 8.3.19.0 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.2.1.1 Description Introduced on the S6000. Introduced on the Z9000. Introduced on the S4820T. Introduced on the S4810. Introduced on the E-Series. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. DellEMC(config-std-nacl)# show conf ! ip access-list standard test remark 5 Permit traffic from XYZ Inc. seq 5 permit 1.1.1.0/24 count remark 10 Deny traffic from ABC seq 10 deny 2.1.1.0/24 count DellEMC(config-std-nacl)# Common IP ACL Commands The following commands are available within both Ingress and Egress IP ACL modes (Standard and Extended) and do not have modespecific options. When an ACL is created without a rule and then is applied to an interface, ACL behavior reflects an implicit permit. The platform supports both Ingress and Egress IP ACLs. NOTE: Also refer to the Commands Common to all ACL Types section. access-class Apply a standard ACL to a terminal line. Syntax access-class access-list-name [ipv4 | ipv6] To remove an ACL, use the no access-class command. Parameters access-list-name ipv4 ipv6 Enter the name of a configured Standard ACL, up to 140 characters. Enter the keyword ipv4 to configure an IPv4 access class. Enter the keyword ipv6 to configure an IPv6 access class. Defaults Command Modes Command History Not configured. LINE This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. 204 Access Control Lists (ACL)