Dell S3100 EMC Command Line Reference Guide for the Series 9.14.1.5 - Page 1920

Example Version 7.6.1.0 7.5.1.0 6.2.1.1 Description Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. DellEMC(conf-if-vrid-4)# show config vrrp-group 4 virtual-address 119.192.182.124 ! DellEMC(conf-if-vrid-4)# show vrrp View the VRRP groups that are active. If no VRRP groups are active, the Dell EMC Networking OS returns No Active VRRP group. Syntax Parameters show vrrp [vrrp-id][brief][interface type][ipv6][interface type][vrf vrf-name] vrrp-id brief interface type (OPTIONAL) Enter the virtual router identifier for the VRRP group to view only that group. The range is from 1 to 255. (OPTIONAL) Enter the keyword brief to view a table of information about the VRRP groups. (OPTIONAL) Enter the following keywords and the interface information: • For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. • For a VLAN interface, enter the keyword vlan, and then the VLAN ID. The VLAN ID range is from 1 to 4094. ipv6 vrf vrf-name (OPTIONAL) Enter the keyword ipv6 to view only VRRP IPv6 groups. (OPTIONAL) Enter the keyword vrf and then the name of the VRF to view active VRRP groups corresponding to that VRF. Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version 9.10(0.1) 9.10(0.0) Description Introduced on the S6010-ON and S4048T-ON. Introduced on the S3148. 1920 Virtual Router Redundancy Protocol (VRRP)