Dell S5248F-ON EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7 - Page 25
Con VLT
![]() |
View all Dell S5248F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
7.1.4 Configure VLT Use 100GbE interfaces for the VLTi between the two leaf switches. This example uses interfaces 1/1/53 and 1/1/54. Remove each interface from Layer 2 mode with the no switchport command. Create the VLT domain. The backup destination is the OOB management IP address of the VLT peer switch. Configure the interfaces used as the VLTi with the discovery-interface command. Enable peer routing. Note: For more information on VLT, see the Dell EMC SmartFabric OS10 User Guide Release 10.5.0. When the configuration is complete, exit configuration mode and save the configuration with the end and write memory commands. Configure VLT - dual switch with VLT S5248F-Leaf1A interface ethernet1/1/53 description VLTi no switchport no shutdown S5248F-Leaf1B interface ethernet1/1/53 description VLTi no switchport no shutdown interface ethernet1/1/54 description VLTi no switchport no shutdown interface ethernet1/1/54 description VLTi no switchport no shutdown vlt-domain 127 backup destination 100.67.172.37 discovery-interface ethernet1/1/531/1/54 peer-routing vlt-domain 127 backup destination 100.67.172.38 discovery-interface ethernet1/1/531/1/54 peer-routing end write memory end write memory 25 Dell EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7
![](/manual_guide/products/dell-powerswitch-s3048on-emc-smartfabric-os10-switch-configuration-guide-vxrail-47-f1f669d/25.png)