Dell S5248F-ON EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7 - Page 30

7.2.4 Configure the switch interconnect Create a port channel to use between the two leaf switches, 127 in this example. Use the switchport mode trunk command to enable the port channel to carry traffic for multiple VLANs, and allow all VLANs on the port channel. Use 100GbE interfaces for the port channel, 1/1/53 and 1/1/54 in this example. Add each interface to the port channel as LACP active members with the channel-group 127 mode active command. When the configuration is complete, exit configuration mode and save the configuration with the end and write memory commands. Configure switch interconnect - dual switch without VLT S5248F-Leaf1A S5248F-Leaf1B interface port-channel 127 description To_Leaf_1B switchport mode trunk switchport trunk allowed vlan 16111615,3939 no shutdown interface port-channel 127 description To_Leaf_1A switchport mode trunk switchport trunk allowed vlan 16111615,3939 no shutdown interface ethernet1/1/53 description To_Leaf_1B channel-group 127 mode active no shutdown interface ethernet1/1/53 description To_Leaf_1A channel-group 127 mode active no shutdown interface ethernet1/1/54 description To_Leaf_1B channel-group 127 mode active no shutdown interface ethernet1/1/54 description To_Leaf_1A channel-group 127 mode active no shutdown end write memory end write memory 30 Dell EMC SmartFabric OS10 Switch Configuration Guide for VxRail 4.7